The Federal Aviation Administration (FAA) has disclosed new details about the technical failure that triggered a nationwide ground stop across the United States on Friday, November 13, disrupting thousands of flights and forcing airlines to cancel approximately 12,462 services.
In a question-and-answer briefing published Sunday, November 15, the FAA said the disruption began at around 3:30 p.m. ET, when instability in its telecommunications network affected communications and radar data used by air traffic controllers.
According to the agency's initial investigation, the problem involved its aging telecommunications infrastructure, which became unstable after an unusually high volume of data flooded the FAA's FTI network. The agency reported receiving approximately 1,000 connection attempts every four to five seconds.
The FAA identified two potential sources of the excessive data traffic: a radar facility in Amarillo, Texas, and a radio communications site in El Dorado, Arkansas.
The Arkansas facility had been undergoing work by L3Harris, the FAA's current network service provider, including the installation of a new router. After detecting inconsistencies in the data, L3Harris blocked traffic from both locations, allowing the network to stabilize.
As an additional precaution, the FAA disabled the broadcasting function on all newly installed routers. The agency said it also disabled the same functionality on approximately 60 similar routers across its network.
17 Air Traffic Control Centers Experienced Instability
The technical problem was not limited to a single facility. According to the FAA, instability initially affected 17 of the country's 22 Air Route Traffic Control Centers before spreading to several Terminal Radar Approach Controls (TRACONs).
The agency stressed that the incident did not result in a complete loss of radar or radio communications. Some frequencies and radar feeds remained operational throughout the disruption, allowing controllers to continue communicating with and tracking aircraft.
The FAA therefore emphasized that established safety procedures remained in place and that pilots and air traffic controllers continued operating under standard protocols.
Approximately 3,500 aircraft were safely landed during the incident, according to the agency. Critical operations, including life-saving, law enforcement and military flights, were also able to continue without reported impacts.
The nationwide ground stop was lifted after the system had remained stable for a period of time. Air traffic resumed at approximately 8:15 p.m. ET on November 13.
12,462 Flight Cancellations Reported
The scale of the disruption was reflected in the cancellation figures published by the FAA.
Approximately 12,462 flights were canceled on Friday, November 13, including 9,082 cancellations by major airlines. The agency cautioned that not all cancellations were directly attributable to the nationwide ground stop, although the wider disruption contributed to the difficult operating conditions.
Airlines have been working to restore schedules and move passengers affected by the cancellations and delays. The FAA said recovery would be gradual as carriers returned to normal operations.
The agency also confirmed that it has no indication, based on currently available evidence, that the incident was caused by a cyberattack or an outside malicious actor.
It further clarified that the failure was not connected to the SMART system or the FAA's broader modernization program. Instead, the initial findings point to instability involving legacy Time-Division Multiplexing (TDM) equipment.